How to Evaluate Nail Heading in PCB drill

2018-11-26 16:45Writer: qyadminReading:

  Nail Heading Evaluation

Nail Heading is a phenomenon that occurs in the drilling of multilayer PWB's. The normal copper inner layers are drawn out or extruded by the drill which forms a nail head like shape on the hole wall.The inner hole wall is inspected by cross-section, the dopper layer is measured where the nail head is formed. The nail heading value is expressed as a percentage according to the thickness of the inner layer copper as shown in the figure below.If the evaluation using stack drilling has been done, all the panels are measured.The maximum nailheading points are measured around final hit hit counts.
 

How to Evaluate Nail Heading in PCB drill

 

  The inner layer copper thickness is measured from the average position of the "roughed" surface of the copper layer.Nail Head[%]= b/a x 100

  a: Copper layer thickness [µm]

  b: Nail head width [µm]

    Related atticles

How to evaluate Holle Registration Accuracy in PCB drill

What is Wicking and how to test it

Compare burrs on market PCB with burrs of our company PCB

What is the correct resin smearing method

Compare Large bird nesting with Small bird nesting

The influence of increasing drilling frequency on drill wearing

Three standard PCB tools evaluation

pcb backup board
pcb back up board backup material